Step 3: Fill e-
Using an e-
Step 4: Screw the eGo CE6 mouthpiece tip back into the eGo CE6 clear tube again. Note: When screwing the mouthpiece back into clearomizer, hold in a vertical/ upright position and not sideways (as shown in demo picture) or liquid can spill out. Allow 3 to 4 minutes for ‘new’ clearomizer to become soaked in liquid before operating. (Subsequent filling do not require waiting time as the head has already been soaked)
Operation: The eGo CE6 e-
Do not suck too hard …use gentle inhalations...Less is more.
How to charge the eGo battery:
Screw the eGo battery into the USB charger, then plug it into a PC or AC-
It is recommended the battery is charged for approximately 8 hours for the 1st charge. Normal charging time thereafter should be kept until the charger light turns green. (approximately 3 hours).
Step 5: Screw the filled eGo CE6 clearomizer with the eGo battery, it will then be in a stand-
Step 1: Pull off the e-
To assemble and use your eGo CE6 electronic cigarette.
Step 2: Unscrew the inhaler tip from the eGo CE6 clearomizer.
Step 1: Unscrew the eGo CE6 clearomizer tube from eGo CE5 clearomizer base
Step 2: Unscrew the used eGo CE6 cartomizer coil head from the top of the base assembly.
Step 3: Screw and tighten the new eGo CE6 clearomizer coil head into the CE6 clearomizer base.
Step 4: Screw the CE6 clearomizer tube back into the eGo CE6 cartomizer base.
How to change the Coil Head on CE6 clearomizer.