Step 3: Fill e-liquid into the eGo CE5 clear tank tube.

Using an e-liquid bottle or syringe, fill the eGo CE5 clear tube by inserting e-liquid down the inside wall of the clearomizer. Tip: Tilt clearomizer slightly. (Do not fill e-liquid in the centre hole, that’s for air flow). Tip: Blow through mouthpiece every time you refill to remove any condensation from previous vaping. (this stops flooding of  the head). Caution: Over filling the clearomizer can lead to liquid spilling into the centre hole which in turn may cause leaking. ie: Do not fill above 1.6 ml marker.

Step 4: Screw the eGo CE5 mouthpiece tip back into the eGo CE5 clear tube again.

Note: When screwing the mouthpiece back into clearomizer, hold in a vertical/ upright position and not sideways (as shown in demo picture) or liquid can spill out. Allow 3 to 4 minutes for ‘new’ clearomizer to become  soaked in liquid before operating. (Subsequent filling do not require waiting time as the head has already been soaked)

On/Off: 5-click safety cutoff. The initial state of the battery setting is Off, click the power button five times within 2 seconds to turn On the battery and five times again (within 2 seconds) to turn Off the battery.


Operation: The eGo CE5 e-cig only works when you press the eGo battery button. Press the button and gently inhale at the same time. .

Do not suck too hard …use gentle inhalations...Less is more.  


How to charge the eGo battery:


Screw the eGo battery into the USB charger, then plug it into a PC or AC-USB Adapter (or mobile portable power pack).


 It is recommended the battery is charged for approximately 8 hours for the 1st charge. Normal charging time thereafter should be kept until the charger light turns green. (approximately 3 hours).

Step 5: Screw the filled eGo CE5 clearomizer with the eGo battery, it will then be in a stand-by state.

Step 1: Pull off the e-liquid bottle lid & Cut off the bottle tip (10 ml bottles)

To assemble and use your eGo CE5  electronic cigarette.   

Step 2: Unscrew the inhaler tip from the eGo CE5 clearomizer.

BestEcig Ireland - Electronic Cigarette Store How to charge your eGo battery

Step 1: Unscrew the eGo CE5 cartomizer tube from eGo CE5 cartomizer base

Step 2: Unscrew the used eGo CE5 clearomizer coil head from the top of the base assembly.

Step 3: Screw and tighten the new eGo CE5 clearomizer coil head into the CE5 clearomizer base

Step 4: Screw the CE5 clearomizer  tube back into the eGo CE5 clearomizer  base.

How to change the Coil Head on CE5 cartomizer.

Manufacturing Electronic Cigarettes since 2007

www.bestecig.ie