Step 3:Fill e-liquid into the E-Smart clear tank tube.
Using an e-liquid bottle or syringe, fill the e-smart clear tube by inserting e-liquid down the inside wall of the clearomizer. Tip: Tilt clearomizer slightly. (Do not fill e-liquid in the centre hole, that’s for air flow). Allow wicks to soak for 2 - 3 minutes before use. (soaking time is not necessary after 1st fill)). Caution: Over filling the clearomizer can lead to liquid spilling into the centre hole which in turn will cause leaking. ie: Do not fill above 1.3ml marker
Step 4: Screw the E-Smart mouthpiece tip back into the E-Smart clear tube again.
Note: When screwing the mouthpiece back into clearomizer, hold in a vertical/ upright position and not sideways (as shown in demo picture) or liquid can spill out.
Tip: Blow through mouthpiece to remove any condensation from previous vaping
On/Off: 5-click safety cutoff. The initial state of the battery setting is Off, click the power button five times within 2 seconds to turn On the battery and five times again (within 2 seconds) to turn Off the battery.
Operation: The E-Smart BCC e-cig only works when you press the E-Smart battery button.
Press the button and gently inhale at the same time.
Do not suck too hard …use gentle inhalations...Less is more.
How to charge the E-Smart battery:
Screw the E-Smart battery into the USB charger, then plug it into a PC or AC-USB Adapter (or mobile portable power pack).
It is recommended the battery is charged for approximately 3 hours for the 1st charge (to increase it’s longevity). Normal charging time thereafter should be kept until the charger light turns green. (approximately 1 hour).
Step 5: Screw the filled E-smart clearomizer onto the E-Smart battery, it will then be in a stand-by state. Press the battery button and gently inhale.
Step 1: Pull off the e-liquid bottle lid & Cut off the bottle tip (10 ml bottles)
To assemble and use your E-Smart electronic cigarette.
Step 2: Unscrew the inhaler tip from the E-Smart clearomizer.